side airbags, rear windshield shade, rear window sunshade and regional air
At present, spray-free plastics have been successfully used in side skirts, central control panels, DVD panels, glove boxes, sunshades, instrument panels and other automotive parts in the automotive field. Bioplastics bioplastics are produced by using original plants as raw materials, such as sugar cane and corn, under the action of microorganisms. Commonly used plastics are generally synthesized from petroleum products, which are often harmful to small molecules that do not fully react, while bioplastics are prepared into automobile interior parts for VOCs volatilization in large vehicles because of the use of renewable raw materials with low toxicity and low harm. In addition, this bioplastic can be decomposed to facilitate subsequent recycling, so it is a more environmentally friendly type of plastic.
The main contents are as follows: 1) the structural design of the window should be reasonable. In the design of the building window, it should not only reflect the control effect of the window on sunlight, but also limit the volume ratio of the window to the wall. If the window area of the building is relatively large, endothermic glass or heat reflection glass can be used, and other shading measures such as balconies, curtains and sunshades can also be taken. If the outdoor temperature is low, natural air can be used as a direct source of energy. Therefore, when designing the construction of the window, you can set a natural pass on it that can open the shoulder;
Honda near Paojiang has no damage to the car stereo, because the car stereo is mostly installed in the upper part of the dashboard, and the sunshade is better to avoid sunlight. If the door and window sealing strip is not strict, it should be replaced, otherwise the loudspeaker is easy to rust and damage, or even cause short circuit to burn the main engine. The specific heat of the circuit board and plastic components in the car audio mainframe is different, so it is affected by the temperature change to a different extent. In the scorching sun, it is good to use the sunshade to resist the scorching sun and avoid the direct sunlight.
Through configuration comparison, it can be seen that the new A6L entry version has added 10 configurations, such as active braking system, matrix LED headlights, inch full liquid crystal meter, inch central control screen, leather dashboard, touch reading light and 12V power supply in the trunk. However, the new car also reduces the four configurations of rear side airbags, rear windshield shade, rear window sunshade and regional air conditioning. On the whole, the 10 additional configurations are better for low-equipped models to enhance the sense of luxury and technology atmosphere, and the reduced configuration can also be made up for by optional equipment.
Most of the telescopic sunshades on the market are made of inferior silver aluminum foil. After direct exposure to the sun, the heating surface of the whole sunshade is easy to soften and difficult to stretch. If it is used for a long time, there will be a strong smell of plastic.